I used the great kit Love Sucks by Bibi's Collection that you can get  at S&Co here, and the wonderful tube that goes with it by Di_Halim that you can get at the same store here.  I started with 700 x 700 in PSP X2 Ultimate.  You should have a knowledge of how to use it.  Papers used were 5, 6, and 7.  Masks used were TBT_CircleMask1, TBT_CircleMask2, and ta8.  They are available at Creative Misfits Creations here. In this process, you can gradient glow and/or drop shadow whenever you want.  From the back, papers 6 and 5 with the Circle Masks are back there.  Element 25 is in front of that with a motion trail and inner bevel from eye candy 3.1.  I did it to one, duplicated, mirrored, and merged those layers down.  Element 27 is in front of that to the size you like, so you can see enough of it.  Element 69 was placed in front of that with enough of it seen.  Element 71 is in front of that in a place I wanted, so you can see part of it.  I duplicated, flipped, and mirrored, so it would be on the bottom backwards.  That way you can see it how I wanted.  Paper 7 with ta8 mask is in front of that.  Element 32 is in front of that.  I placed it in the corner, so I could see the edges, duplicated, and mirrored.  That way, one is in each corner.  Element 82 is in front of that placed where I could see it and where I wanted.  Element 83 was placed on the bottom to be seen, duplicated, and flipped to have one on both top and bottom.  Element 53 is in front of that.  I placed it on the side how I wanted, duplicated, mirrored, and flipped it, so they were going the opposite ways.  Choose a frame you want to use, use the magic wand to select it, put whatever layer of the tube you want on it, and promote that layer.  Delete the part that isn't promoted.  Put that image where you want, and I put mine, so the bottom could not be seen.  Element 29 is in front of that. I used eye candy 5 bevel on it and placed it in a corner.  From there, I duplicated, mirrored, and flipped to have one in each corner.  Element 85 was sized how I wanted and placed near the heart element, so it can be seen and read.  From there, I put the tube I wanted, the artist's copyright, my watermark, whatever statement, and a name on it.  Below, I have a couple another tag with the same tube, and one with an Exclusive PFD tube made by Origash.  You can email me about anything.